Back to Blog
Emby client linux6/7/2023 We’ll discuss the prerequisites to get started, how to install the Emby Theater software, and how to configure it for optimal performance. In this article, we’ll walk you through the steps to get the Emby Theater up and running on your Linux Mint system. To run this at startup you could easily add that to the crontab file to run at reboot, a better way would probably be to add it as a system service so that it could be set to restart if it crashes.If you’re a Linux Mint user and you’re looking to get your hands on the popular media center, Emby Theater, you’ve come to the right place. Your Emby-Server should now be available for you at Also, don’t forget too add the addons for Kodi - They are available on Test your creation (sudo might not be required): sudo mono /opt/mediabrowser/ -ffmpeg “/usr/local/share/man/man1/ffmpeg.1” -ffprobe “/usr/local/share/man/man1/ffprobe.1” To find the name of the actual file and enter it in the config files 5) Cleanup: sudo apt-get clean To list all your installed packages, make a note of the exact names of the packages for libMagickWand, sqlite3 and mediainfo and then run dpkg -L If this doesn’t work for you, the easiest way to do this yourself is to run dpkg-query -f '$\n' -W It should be safe to just copy my files, but if you run into troubles you can edit them yourself using the instructions at the bottom of this section: Unzip /tmp/ -d /opt/mediabrowserĬonfigure by editing the following three files so that they point to the correct versions of their corresponding libraries. The next step is to get and configure Emby.ĭownload and unpack wget -O /tmp/ sudo apt-key adv -keyserver hkp://:80 -recv-keys 3FA7E0328081BFF6A14DA29AA6A19B38D3D831EFĮcho "deb wheezy main" | sudo tee /etc/apt//mono-xamarin.list Therefore we need to get it from the maker of mono, Xamarin. While available through the official debian repo that version (2.3) is too old - Recommended version is ≥4. The next step is to get mono (the package, not the disease). I left this on overnight sudo aptitude remove ffmpeg sudo aptitude install imagemagick imagemagick-6.q16 imagemagick-common libimage-magick-perl libimage-magick-q16-perl libmagickcore-6-arch-config libmagickcore-6-headers libmagickcore-6.q16-2 libmagickcore-6.q16-2-extra libmagickcore-6.q16-dev libmagickwand-6-headers libmagickwand-6.q16-2 libmagickwand-6.q16-dev libmagickwand-dev webp mediainfo sqlite3 If it doesn’t, try splitting these into several commands instead of installing them at once. Be sure to check the suggestions that aptitude throws at you, it might suggest to skip some of the packages, just say no to that suggestion until a better one comes along. Can be installed through apt-get: sudo apt-get install aptitude unzip git Please tell me if you’ve tried the guide and something doesn’t work and I’ll try to get it sortedĪptitude, unzip, git. Also it was a pain to get this up and running without instructions, thus these instructions are made as an afterthought and I might’ve missed something. Haven’t integrated it into my Kodi installation yet so I can’t say how that works either, basically this is a proof of concept. Haven’t tried streaming or other DLNA devices yet so I can’t vouch for that. #Note: I have Emby-Server running flawlessly on my OSMC rpi2. While they aren’t that complicated they do require you to be somewhat familiar with the terminal and have a bit of free time.
0 Comments
Read More
Leave a Reply. |